| Wheelchairs | Scooters | Floorcare | Materials Handling | Golf Carts | Utility | Aerial Work Platforms |
| R-net | VR2 | VSI | S-Drive | X25 & X30 | Sigmadrive | Trio+ | Access | I-Drive | Solo |
| Product Range | Programmers | Accessories | Gauges | Other Products |
| Customer Services | eWarranty | Diagnostics | VR2 Field Servicing | Applications Support | Downloads Section | FAQ |
| About PGDT | Approvals | Offices | Recruitment | Terms & Conditions |
| Accredited Repairs | GOALS |
| PGDT Offices | PGDT Partners | PGDT Repair Centers |
  English
PGDT :: Enhancing Customer Servcie at all Levels
   
 
R-net Wheelchair Control System
VR2 Wheelchair Control System
VSI Wheelchair Control System
S-Drive Scooter Controller
X25/X30 Motor Controller
Sigma Series
Access - Aerial Work Platform Control System
Trio+ Floorcare Machine Controller
I-Drive Motor Controller
Solo Motor Controller
 
PGDT: TruCharge 1 Low Battery Voltage
The battery needs charging or there is a bad connection to the battery. Check the connections to the battery. If the connections are good, try charging the battery.

PGDT: TruCharge 2 Motor Disconnected
The motor has a bad connection. Check all the connections and leads between the motor and the Egis. Check the position of the freewheel switch.

PGDT: TruCharge 3 Motor Wiring Trip
The motor has a short circuit to a battery connection. Check all the connections and leads between the motor and the battery.

PGDT: TruCharge 4 Freewheel Switch Trip
The freewheel switch or manual disengagement mechanism is operated. This is instigated only on systems where there is a switch wired to the Egis' Freewheel input. Check the position of the switch and all connections between the switch and the Egis.

PGDT: TruCharge 5 Not Used



PGDT: TruCharge 6 Charger Connected
The Egis is being inhibited from driving This may be because the battery charger is connected or the seat is not in the driving position.

PGDT: TruCharge 7 Throttle Trip
A throttle trip is indicated. Make sure that the throttle is in the neutral position before switching on the scooter.


PGDT: TruCharge 8 Possible Controller Trip
A controller trip is indicated. Make sure that all connections are secure.


PGDT: TruCharge 9 Solenoid Brake Trip
There is a bad connection to the parking brake. Some scooters will register this error type when the freewheel lever is disengaged. Firstly, check the freewheel lever is in the active position, then check all connections between the parking brake and the Egis.

PGDT: TruCharge 10 High Battery Voltage
An excessive voltage has been applied to the control system. This is usually caused by a poor battery connection. Check the battery connections.

Commonly Seen Informational Flash Codes

PGDT: Control System in Sleep Mode Control System in Sleep Mode
The control system has entered sleep mode. Switch the scooter off and then on again.


PGDT: Joystick Displaced Throttle Displaced
The throttle has been displaced while the scooter is being switched on. Place the throttle in the neutral position and turn the scooter off and on again.


If the problems persist after you have made the checks described above, then please contact your service agent.
| USA : +1 714 712 7911 | UK : +44 (0)1425 271444 | TAIWAN : +886 (0)2 2579 1821 | HONG KONG : +852 2 293 2621 |
| About PGDT | Site Map | Contact Us | Terms & Conditions | Legal |
©2006 PG Drives Technology